Skip to contentSoftenerMath

Calculator Water hardness San Antonio

San Antonio water hardness and softener cost

San Antonio's tap water is typically about 17.5 grains per gallon (299 mg/L). That is very hard. Expect scale in kettles, water heaters and on fixtures. Most homeowners here find a softener worth it.

How hard is San Antonio's water?

The San Antonio Water System (SAWS) supplies San Antonio. Its water is typically about 17.5 gpg (299 mg/L), which is very hard. The utility reports a range of 15 to 20 gpg (257 to 342 mg/L) across its system, and we use the middle of that range.

Source: SAWS water quality FAQ (typical range 15 to 20 gpg), 2026. Hardness isn't a health standard, so utilities report it as a quality figure. Your own tap may differ, especially if your area is served by a different plant or wells.

Where San Antonio's water comes from

  • SAWS says the hardness comes from calcium carbonate that occurs naturally in water from the Edwards and Trinity aquifers. SAWS water quality FAQ.
  • The Edwards Aquifer supplies over half of San Antonio's drinking water. SAWS manages 13 supply projects from seven sources to reduce its reliance on the aquifer. SAWS water supply.

What a softener costs in San Antonio

Our calculator at 17.5 gpg, for a salt-based softener installed by a plumber, with an existing softener loop. Plumbers in the San Antonio-New Braunfels, TX area earn a mean $27.87 an hour, 20% below the national mean of $34.70 (BLS, May 2025), so we scaled plumber labor to match.

2 people, 32,000 grains
Installed
$630 to $2,810
Per year
$65 to $470
10-year total
$1,280 to $7,530
4 people, 64,000 grains
Installed
$1,030 to $3,210
Per year
$110 to $580
10-year total
$2,080 to $9,050
6 people, 80,000 to 96,000 grains
Installed
$1,730 to $3,510
Per year
$140 to $700
10-year total
$3,180 to $10,470

Sizes are in grains of rated capacity. The range in each cell runs from a big-box unit you install with a plumber to a higher-end system. Water, salt and upkeep are in the yearly figure. Every input and its source is on the methodology page.

Get your exact number

Read the SAWS water quality FAQ from the San Antonio Water System (SAWS), or look up your own ZIP code on our hardness lookup. On a private well, test your water: city figures don't apply.

Other cities

Data last checked Nov 2026.

Common questions

Is San Antonio water hard?
Yes. San Antonio's water is typically about 17.5 gpg (299 mg/L), which is very hard on the scale used by Penn State Extension. Source: SAWS water quality FAQ (typical range 15 to 20 gpg), 2026.
Do I need a water softener in San Antonio?
A softener is strongly recommended. At 17.5 gpg, a family of 4 needs about a 64,000-grain salt-based softener.
How much does a water softener cost in San Antonio?
For a family of 4, about $1,030 to $3,210 installed and $110 to $580 a year to run, or $2,080 to $9,050 over 10 years. Plumber labor is adjusted for local wages.

Numbers on this page come from our cost inputs and sources, last reviewed 2026-11.